Calibration needed
refer to calibration support page for more.
Manual Calibration
If you are using this way to perform calibration, you need to have below things prepared:
1.Voltage Meter. This meter must provide higher accuracy than the Neware testing systems you are going to calibrate, and the calibration is valid.
2.DC Shunt. If your multi-meter provides good current measurement capability, you can directly use it. Calibration of the 3.DC shunt must be valid.
4.Power Sink. This is usually a resistor with enough power capability when you apply a constant voltage on it.
5.Power Supply.This is usually a battery with enough power capability when you apply a constant discharging current on it.
After you get above items prepared and well configured for below parts
1.Charge Current
2.Discharge Current
3.Charge Voltage
4.Discharge Voltage or Voltage Measurement
5.By sample estimating, you will need much work by switching the external circuit and inputting those meter readings.
Auto Calibration
With our auto calibrator, you can perform calibration process, pre-calibration (As Found) and/or post-calibration (As Left) tests by one click on the mouse
Diagram
Verification Report
